The first step of using electrical tape: prepare, electrical tape and knife.
The second step of using electrical tape: peel off one end of the two power supplies to expose the copper wire, and the length is moderate.
The third step of using electrical tape: Cross the two power supplies and wind them together. Remember to wind it tightly and make the entanglement firm.
The fourth step of using electrical tape: Wrap the electrical tape from one end of the cross to the other. Remember, in the process of wrapping, you must use a little bit of strength, don’t just wind it up, use a little bit of strength to wind up the electrical tape. Yes, firmly. If you twist and tie it casually, as time lengthens, it is very likely that the tape will slowly loosen, loosen, and fall off. This is very dangerous, and it must be tied tightly.
